|
Record |
Links |
|
Author |
Kirilenko, D.A.; Brunkov, P.N. |
|
|
Title |
Measuring the height-to-height correlation function of corrugation in suspended graphene |
Type |
A1 Journal article |
|
Year |
2016 |
Publication |
Ultramicroscopy |
Abbreviated Journal |
Ultramicroscopy |
|
|
Volume |
165 |
Issue |
165 |
Pages |
1-7 |
|
|
Keywords |
A1 Journal article; Electron Microscopy for Materials Science (EMAT); |
|
|
Abstract |
Nanocorrugation of 2D crystals is an important phenomenon since it affects their electronic and mechanical properties. The corrugation may have various sources; one of them is flexural phonons that, in particular, are responsible for the thermal conductivity of graphene. A study of corrugation of just the suspended graphene can reveal much of valuable information on the physics of this complicated phenomenon. At the same time, the suspended crystal nanorelief can hardly be measured directly because of high flexibility of the 2D crystal. Moreover, the relief portion related to rapid out-of-plane oscillations (flexural phonons) is also inaccessible by such measurements. Here we present a technique for measuring the Fourier components of the height-height correlation function H(q) of suspended graphene which includes the effect of flexural phonons. The technique is based on the analysis of electron diffraction patterns. The H(q) is measured in the range of wavevectors q approximately 0.4-4.5nm(-1). At the upper limit of this range H(q) does follow the T/kappaq(4) law. So, we measured the value of suspended graphene bending rigidity kappa=1.2+/-0.4eV at ambient temperature T approximately 300K. At intermediate wave vectors, H(q) follows a slightly weaker exponent than theoretically predicted q(-3.15) but is closer to the results of the molecular dynamics simulation. At low wave vectors, the dependence becomes even weaker, which may be a sign of influence of charge carriers on the dynamics of undulations longer than 10nm. The technique presented can be used for studying physics of flexural phonons in other 2D materials. |
|
|
Address |
Ioffe Institute, Politekhnicheskaya ul. 26, 194021 St-Petersburg, Russia; ITMO University, Kronverksky pr. 49, 197101 St. Petersburg, Russia |
|
|
Corporate Author |
|
Thesis |
|
|
|
Publisher |
|
Place of Publication |
|
Editor |
|
|
|
Language |
English |
Wos |
000375946200001 |
Publication Date |
2016-03-28 |
|
|
Series Editor |
|
Series Title |
|
Abbreviated Series Title |
|
|
|
Series Volume |
|
Series Issue |
|
Edition |
|
|
|
ISSN |
0304-3991 |
ISBN |
|
Additional Links |
|
|
|
Impact Factor |
2.843 |
Times cited |
3 |
Open Access |
|
|
|
Notes |
D.K. thanks the RFBR (Grant no. 16-32-60165) for the partial support of this research. The work was carried out in part at the Joint Research Center “Material Science and Characterization in Advanced Technologies” (St-Petersburg, Russia) under the financial support from the Ministry of Education and Science of the Russian Federation (Agreement 14.621.21.0007, 04.12.2014, id RFMEFI62114X0007, the use of the Jeol JEM-2100F microscope) and at EMAT, Universiteit Antwerpen (Antwerpen, Belgium), (the use of the FEI Tecnai G2 microscope). |
Approved |
Most recent IF: 2.843 |
|
|
Call Number |
EMAT @ emat @ |
Serial |
4124 |
|
Permanent link to this record |