| |
Records |
Links |
|
Author |
Longo, R.; Ferrarotti, M.; Garcia Sánchez, C.; Derudi, M.; Parente, A. |
|
| |
Title |
Advanced turbulence models and boundary conditions for flows around different configurations of ground-mounted buildings |
Type |
A1 Journal article |
| |
Year  |
2017 |
Publication |
Journal of wind engineering and industrial aerodynamics |
Abbreviated Journal |
J Wind Eng Ind Aerod |
|
| |
Volume |
167 |
Issue |
|
Pages |
160-182 |
|
| |
Keywords |
A1 Journal article; Electron microscopy for materials research (EMAT) |
|
| |
Abstract |
When dealing with Atmospheric Boundary Layer (ABL) simulations, commercial computational fluid dynamics (CFD) acquires a strategic resonance. Thanks to its good compromise between accuracy of results and calculation time, RANS still represents a valid alternative to more resource-demanding methods. However, focusing on the models' performances in urban studies, LES generally outmatches RANS results, even if the former is at least one order of magnitude more expensive. Consequently, the present work aims to propose a variety of approaches meant to solve some of the major problems linked to RANS simulations and to further improve its accuracy in typical urban contexts. All of these models are capable of switching from an undisturbed flux formulation to a disturbed one through a local deviation or a marker function. For undisturbed flows, a comprehensive approach is adopted, solving the issue of the erroneous stream-wise gradients affecting the turbulent profiles. Around obstacles, Non-Linear Eddy-Viscosity closures are adopted, due to their prominent capability in capturing the anisotropy of turbulence. The purpose of this work is then to propose a new Building Influence Area concept and to offer more affordable alternatives to LES simulations without sacrificing a good grade of accuracy. |
|
| |
Address |
|
|
| |
Corporate Author |
|
Thesis |
|
|
| |
Publisher |
|
Place of Publication |
Amsterdam |
Editor |
|
|
| |
Language |
|
Wos |
000405766600013 |
Publication Date |
2017-05-02 |
|
| |
Series Editor |
|
Series Title |
|
Abbreviated Series Title |
|
|
| |
Series Volume |
|
Series Issue |
|
Edition |
|
|
| |
ISSN |
0167-6105 |
ISBN |
|
Additional Links |
UA library record; WoS full record; WoS citing articles |
|
| |
Impact Factor |
2.049 |
Times cited |
9 |
Open Access |
Not_Open_Access |
|
| |
Notes |
; ; |
Approved |
Most recent IF: 2.049 |
|
| |
Call Number |
UA @ lucian @ c:irua:145191 |
Serial |
4713 |
|
| Permanent link to this record |
| |
|
| |
|
Author |
Ercolani, G.; Gorle, C.; Garcia Sánchez, C.; Corbari, C.; Mancini, M. |
|
| |
Title |
RAMS and WRF sensitivity to grid spacing in large-eddy simulations of the dry convective boundary layer |
Type |
A1 Journal article |
| |
Year |
2015 |
Publication |
Computers and fluids |
Abbreviated Journal |
Comput Fluids |
|
| |
Volume |
123 |
Issue |
123 |
Pages |
54-71 |
|
| |
Keywords |
A1 Journal article; Electron microscopy for materials research (EMAT) |
|
| |
Abstract |
Large-eddy simulations (LESS) are frequently used to model the planetary boundary layer, and the choice of the grid cell size, numerical schemes and sub grid model can significantly influence the simulation results. In the present paper the impact of grid spacing on LES of an idealized atmospheric convective boundary layer (CBL), for which the statistics and flow structures are well understood, is assessed for two mesoscale models: the Regional Atmospheric Modeling System (RAMS) and the Weather Research and Forecasting model (WRF). Nine simulations are performed on a fixed computational domain (6 x 6 x 2 km), combining three different horizontal (120, 60, 30 m) and vertical (20, 10, 5 m) spacings. The impact of the cell size on the CBL is investigated by comparing turbulence statistics and velocity spectra. The results demonstrate that both WRF and RAMS can perform LES of the CBL under consideration without requiring extremely high computational loads, but they also indicate the importance of adopting a computational grid that is adequate for the numerical schemes and subgrid models used. In both RAMS and WRF a horizontal cell size of 30 m is required to obtain a suitable turbulence reproduction throughout the CBL height. Considering the vertical grid spacing, WRF produced similar results for all the three tested values, while in RAMS it should be ensured that the aspect ratio of the cells does not exceed a value of 3. The two models were found to behave differently in function of the grid resolution, and they have different shortcomings in their prediction of CBL turbulence. WRF exhibits enhanced damping at the smallest scales, while RAMS is prone to the appearance of spurious fluctuations in the flow when the grid aspect ratio is too high. (C) 2015 Elsevier Ltd. All rights reserved. |
|
| |
Address |
|
|
| |
Corporate Author |
|
Thesis |
|
|
| |
Publisher |
|
Place of Publication |
Oxford |
Editor |
|
|
| |
Language |
|
Wos |
000365367500006 |
Publication Date |
2015-10-08 |
|
| |
Series Editor |
|
Series Title |
|
Abbreviated Series Title |
|
|
| |
Series Volume |
|
Series Issue |
|
Edition |
|
|
| |
ISSN |
0045-7930 |
ISBN |
|
Additional Links |
UA library record; WoS full record; WoS citing articles |
|
| |
Impact Factor |
2.313 |
Times cited |
3 |
Open Access |
|
|
| |
Notes |
|
Approved |
Most recent IF: 2.313; 2015 IF: 1.619 |
|
| |
Call Number |
UA @ lucian @ c:irua:130200 |
Serial |
4236 |
|
| Permanent link to this record |
| |
|
| |
|
Author |
Gorle, C.; Garcia Sánchez, C.; Iaccarino, G. |
|
| |
Title |
Quantifying inflow and RANS turbulence model form uncertainties for wind engineering flows |
Type |
A1 Journal article |
| |
Year |
2015 |
Publication |
Journal of wind engineering and industrial aerodynamics
T2 – 6th International Symposium on Computational Wind Engineering (CWE), JUN 08-12, 2014, Hamburg, GERMANY |
Abbreviated Journal |
J Wind Eng Ind Aerod |
|
| |
Volume |
144 |
Issue |
144 |
Pages |
202-212 |
|
| |
Keywords |
A1 Journal article; Electron microscopy for materials research (EMAT) |
|
| |
Abstract |
Reynolds-averaged Navier-Stokes (RANS) simulations are often used in the wind engineering practice for the analysis of turbulent bluff body flows. An approach that allows identifying the uncertainty related to the use of reduced-order turbulence models in RANS simulations would significantly increase the confidence in the use of simulation results as a basis for design decisions. In the present study we apply a strategy that enables quantifying these uncertainties by introducing perturbations in the Reynolds stress tensor to simulations of the flow in downtown Oklahoma City. The method is combined with a framework to quantify uncertainties in the inflow wind direction and intensity, and the final result of the UQ approach is compared to field measurement data for the velocity at 13 locations in the downtown area. (C) 2015 Elsevier Ltd. All rights reserved. |
|
| |
Address |
|
|
| |
Corporate Author |
|
Thesis |
|
|
| |
Publisher |
Elsevier science bv |
Place of Publication |
Amsterdam |
Editor |
|
|
| |
Language |
|
Wos |
000360874900023 |
Publication Date |
2015-08-18 |
|
| |
Series Editor |
|
Series Title |
|
Abbreviated Series Title |
|
|
| |
Series Volume |
|
Series Issue |
|
Edition |
|
|
| |
ISSN |
0167-6105 |
ISBN |
|
Additional Links |
UA library record; WoS full record; WoS citing articles |
|
| |
Impact Factor |
2.049 |
Times cited |
22 |
Open Access |
|
|
| |
Notes |
|
Approved |
Most recent IF: 2.049; 2015 IF: 1.414 |
|
| |
Call Number |
UA @ lucian @ c:irua:127843 |
Serial |
4230 |
|
| Permanent link to this record |
